HSM-V6000 High Vacuum Cold Mounting Press Automatic Vacuum Inlay Machine for Metallographic Sample Preparation

HSM-V6000 High Vacuum Cold Mounting Press Automatic Vacuum Inlay Machine for Metallographic Sample Preparation

The HSMV-6000 fully automatic vacuum cold setting machine, with PLC control, high-strength vacuum chamber and built-in vacuum pump, can complete the entire setting process with one click, including multiple vacuuming, maintaining vacuum, venting, etc.

Sample mounting, by removing air from the sample and the cold mounting material, the liquid mounting material fills the gaps in the sample, eliminating the gaps between the sample and the mounting material, thus achieving tight bonding between the sample and the mounting material. The sample is also well protected and supported during grinding and polishing.

I, Main functions

1. High vacuum: -0.06MPa(-60 kpa)

2. One click to complete the entire setting process including multiple vacuuming, holding vacuum, venting cycles, etc.

3. The process parameters such as vacuum degree, vacuum holding time, venting, cycle number, and setting completion reminder can all be set;

4. 999 sets of process parameters, set according to different materials and samples, password-protected for easy access;

5. Quickly reach the set high vacuum.

6. Large volume, transparent vacuum chamber;

7. Built-in vacuum pump, low noise, oil-free, pollution-free, maintenance-free

8. Both the inlaid sample and the liquid inlay can be pre-evacuated;

9. Using the rotating cup holder in the vacuum container, multiple samples can be poured into the mold in a vacuum at one time for vacuum mounting;

10. Special vent valves are available for multiple cycles of vacuuming and venting insert processes.

II, Technical Parameters

III, How to use

1. Place the inlay mold in a vacuum chamber;

2. Mix the cold inlay in proportion, pour it into a disposable plastic cup, and place the plastic cup on the cup holder in the container; Cover the top lid of the vacuum chamber;

3. Perform pre-vacuuming as needed;

4. Pour the inlay into the inlay mold;

5. Select the sequence number of the required inlay process parameters by name and press the "Start" button to begin the fully automatic inlay process;

6. Wait until the machine gives a prompt sound to complete the entire process of setting.

IV, Standard Configuration

high vacuum cold mounting press

automatic vacuum inlay machine

metallographic sample preparation equipment

HSM-V6000 High Vacuum Cold Mounting Press Automatic Vacuum Inlay Machine for Metallographic Sample Preparation Images